ETI-Research FC-TC07 female RCA connector
is proud to announce the new FC-TC-07 female RCA Connector.
The design still follows the philosophy of the ground
breaking PhonoPod which was in the forefront of Design
for Sound Enhancement.
FC-TC07 has been able to maintain the best of the PhonoPod
but offers some improvements for sonic purity. The Signal
Pin is now made from Pure Copper to give a higher degree
of signal transfer. The
Solder Pins have been curved to improve in Soldering
which will make sure that the wire is able to be secured
in a quality soldering connection.
PhonoPod had the nut made of Tellurium Copper and it
screwed directly onto the PhonoPod. While this is still
a great way for connection it did not protect against
the EMI/RF noise that is so prevalent nowadays. The
FC-TC07 has the nut made from Brass because it has excellent
damping of vibrations and is also excellent at rejecting
the EMI/RF noise. This helps to make sure that any noise
that is surround by equipment is not interfering with
Brass nut threads onto a Polymer Base so that it does
not make contact with the connector.
• Lengths and masses of signal and return pins
connectors made as thin as possible to maintain durability.
• Low mass signal conductor made from Pure Copper
which with reduced inductive reactance for superior,
extended bandwidth, better high-frequency response and
• Matched to the thinnest possible Tellurium Copper,
low mass ground outer shell that transmits the ground
signal at lightning speed away.
• Curved Signal Conductors for superior soldering
• Brass nut that offers great vibration damping
and excellent EMI/RF noise rejection screws onto a Polymer
thread. So no contact with the Signal.
no Nickel, no Brass, no Bronze – for extreme conductivity
and better signal transfer.
ETI-Research is very proud of this design and we are
sure you will agree.